Honeywell Performance Series User Manual

Configuring Event Settings
89
Figure 8-12 Username Abnormality Configuration Tab
2. On the Username tab, in the Event Type box, select the event type for which you want to
configure.
3. Select the Enable check box to enable username error detection for the selected event
type.
4. Select the actions that you want the system to initiate when the selected event occurs:
Alarm Out: Select the check box to activate the selected alarm output(s) (1 or 2). In the
Latch box, specify the amount of time (0–300 s) to delay the alarm output signal after the
network event is triggered.
Send Email: Select the check box to enable the system to send an email notification. To
set up Email settings, see Configuring Email Settings on page 68.
Voice Prompts: Select the check box to enable the playing of a voice prompt audio file
when a network event is triggered. Use the File Name drop-down arrow to select the audio
file to play for network events.
Buzzer: Select the check box to activate a buzzer noise at the NVR.
Log: Select the check box to enable logging of network events.
5. Click Apply to save your settings.
Configuring Alarm Input Settings
Configuring IPC External Alarms
To configure IPC external alarms
1. Go to Main Menu  SETTING  EVENT  ALARM  IPC Ext.

Honeywell Performance Series Specifications

General

Brand	Honeywell
Model	Performance Series
Category	IP Camera
Language	English