Honeywell Performance Series User Manual

Performance Series Network Video Recorder User Guide
58
Configuring Encoding Settings
1. Go to Main Menu  Setting  CAMERA  Encode Encode Mode, the following
window is displayed:
Figure 6-4 Camera Encoding Settings Tab
2. On the Encode tab, in the Channel box, select the camera that you want to configure.
Note
If the NVR fails to retrieve the configuration information for
your selected camera/channel, then you should navigate to a
different window (such as Snapshot or Overlay), then navigate
back to the Encode window.
3. Configure the following settings for the primary stream and secondary stream:
Note Parameters vary according to products.
Code Stream Type: Set the primary stream type as General, MD (Motion Detection), or
Alarm. The sub stream(s) type is not configurable.
Compression: Select the video encode mode.
Smart Codec: Set the Smart Codec as either Close (default) or Enable. This function is to
reduce bit streams.

Honeywell Performance Series Specifications

General

IR Range	Up to 30m (98ft)
Weatherproof Rating	IP66
Power Supply	PoE (Power over Ethernet) IEEE 802.3af, 12 VDC
Image Sensor	1/2.8" CMOS
Vandal Resistance	IK10
Video Compression	H.265/H.264/MJPEG
Storage	MicroSD card slot (up to 256GB)
Network Connectivity	10/100 Mbps Ethernet