Honeywell Performance Series User Manual

Getting Started
17
Device Initialization
When the NVR has booted up, the system enters the Device Initialization window.
Figure 2-2 Device Initialization – Enter Password
1. Enter the password according to the password requirements. The default username is
admin.
You can use the USB mouse to change the password. Click the soft keyboard button to
switch the input mode between numbers and English letters; click Shift to change
between lowercase and uppercase.
2. Click Next and the following window is displayed:
Figure 2-3 Device Initialization-Unlock Pattern

Honeywell Performance Series Specifications

General

IR Range	Up to 30m (98ft)
Weatherproof Rating	IP66
Power Supply	PoE (Power over Ethernet) IEEE 802.3af, 12 VDC
Image Sensor	1/2.8" CMOS
Vandal Resistance	IK10
Video Compression	H.265/H.264/MJPEG
Storage	MicroSD card slot (up to 256GB)
Network Connectivity	10/100 Mbps Ethernet