Honeywell Performance Series User Manual

Performance Series Network Video Recorder User Guide
244
Note
The procedure for installing a hard drive is different depending
on what NVR unit you have. Check the model number of your
NVR and make sure that you refer to the section that applies to
your NVR unit:
• Installing a HDD on
HEN081*4/HEN161*4/HEN321*4/HEN041*3/HEN081*3/
HEN161*3/ HEN04103L/ HEN08103L/ HEN16103L/
HEN32103L on page 244.
• Installing a HDD on HEN162*4/HEN322*4/HEN642*4 on
page 246.
• Installing a HDD on HEN163*4/HEN323*4/HEN643*4 on
page 248.
Installing a HDD on
HEN081*4/HEN161*4/HEN321*4/HEN041*3/HEN081*3/
HEN161*3/ HEN04103L/ HEN08103L/ HEN16103L/ HEN32103L
1. Loosen the screws on the upper cover and side panel of the NVR, remove the cover, and
set it aside.
Figure 15-1 Removing the NVR Cover
2. Loosen four screws on the HDD.
Figure 15-2 Loosening the Four Screws in the HDD Housing
3. Align the HDD with the four holes in the bottom of the NVR housing.

Honeywell Performance Series Specifications

General

IR Range	Up to 30m (98ft)
Weatherproof Rating	IP66
Power Supply	PoE (Power over Ethernet) IEEE 802.3af, 12 VDC
Image Sensor	1/2.8" CMOS
Vandal Resistance	IK10
Video Compression	H.265/H.264/MJPEG
Storage	MicroSD card slot (up to 256GB)
Network Connectivity	10/100 Mbps Ethernet