Honeywell Performance Series User Manual

Performance Series Network Video Recorder User Guide
118
To synchronize the system time with the Network Time Protocol (NTP)
1. Ensure that the NVR is connected to the Internet.
2. Go to Main Menu  SETTING  SYSTEM  GENERAL  Date&Time.
3. On the Date&Time tab, click to select the NTP check box.
4. In the Server box, enter the IP address of the NTP server that you want to use (for example,
time.nist.gov).
5. Ensure that Port is set to 123.
6. To change the frequency with which the system time synchronizes with the NTP server,
enter a new time in the Interval box. The default setting is 60 min.
7. Click Manual Update to manually synchronize your system time with the NTP server.
8. Click Apply to save your settings.
9. If you want to save your settings and exit the SETTING menu, click OK.
Configuring Holiday Settings
1. Go to Main Menu  SETTING  SYSTEM  GENERAL  Holiday.
Figure 10-3 Holiday Tab
2. On the Holiday tab, click Add Holidays. The Add Holidays window appears.

Honeywell Performance Series Specifications

General

IR Range	Up to 30m (98ft)
Weatherproof Rating	IP66
Power Supply	PoE (Power over Ethernet) IEEE 802.3af, 12 VDC
Image Sensor	1/2.8" CMOS
Vandal Resistance	IK10
Video Compression	H.265/H.264/MJPEG
Storage	MicroSD card slot (up to 256GB)
Network Connectivity	10/100 Mbps Ethernet