Web Client Operation
201
Table 12-21 WEB - Alarm Configurations
Configuration Description
Enable Click to enable alarms. Select a channel from the drop-down list.
Period
1. Click Setup. The Set configuration interface appears.
2. Select a day of the week check box. Select from a day of the week or
All.
Note: If you select All, the set schedule will apply to all days of the week.
Note: You can configure up to 6 periods within a day.
3. Configure a time range for when the alarm is active, then click the
Period check box to select that time range for the selected day of
the week.
4. Repeat steps 2 and 3 to set up multiple time periods in a day or to
setup other days of the week, as required.
5. Click OK.
Alternative Setup Method You can use the time and day graph in the
upper part of the screen to configure the time periods needed for
alarms.
Use the mouse to click, and click/drag over different parts of the graph
to enable or disable alarms for those times/days.
Anti-dither
The system can delay recording for a specified amount of time after an
alarm has ended. Select from 0s to 600s.
Type Select either NO or NC.
Record Channel
The system automatically starts recording selected channels when a
motion detection alarm occurs.
To Next Page
Loading...
Need help?
General
