Document 800-12006V2 – Rev A – 07/2012
HRG4, HRG8, HRG16 Performance DVRs
Getting Started Guide
Document 800-12006V2 – Rev A – 07/2012
This document describes the installation and operation procedures for the following Performance Series Honeywell
DVRs:
• HRG4 4-Channel DVR
• HRG8 8-Channel DVR
• HRG16 16-Channel DVR
This document is for system integrators, installers, and end-user operators.
For more detailed information than is contained in this guide, refer to the User Guide, located on the software cd.
Cautions and Warnings
CAUTION Use only the supplied power supply.
Compliance
Information to the User: This equipment has been tested and found to comply with the limits for a Class A digital
device. Pursuant to part 15 of the FCC Rules, these limits are designed to provide reasonable protection against
harmful interference in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which
case the user will be required to correct the interference at his own expense.
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Canadian Compliance Statement
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la Classe A est conforme à la norme NMB-003 du Canada.
CAUTION
THIS SYMBOL INDICATES THAT
DANGEROUS VOLTAGE
CONSTITUTING A RISK OF
ELECTRIC SHOCK IS PRESENT
WITHIN THE UNIT.
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE THE COVER.
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
THIS SYMBOL INDICATES THAT
IMPORTANT OPERATING AND•
MAINTENANCE INSTRUCTIONS
ACCOMPANY THIS UNIT.
RISK OF ELECTRIC
SHOCK
DO NOT OPEN
To Next Page
Need help?
General