Document 800-12006V2 Rev A 11
07/2012
Setting Up the DVR with the Setup Wizard
Note Please ensure that the DVR has been installed with HDD before access to the
Setup Wizard. By default, the Setup Wizard will start once the DVR has loaded,
as shown in Figure . The Setup Wizard will guide you through some important
settings of your DVR. Select Next if the DVR has been installed with HDD, or
click Cancel to access Live View window if no HDD is installed.
By default, the Setup Wizard will start after the DVR has loaded. The Setup Wizard will walk you through some of the
more important settings of your DVR. If you do not wish to use the Setup Wizard at this time, click the Cancel button.
You can also choose to use the Setup Wizard at a later time by leaving the Start Wizard when DVR starts? checkbox
checked.
Using the Setup Wizard for Initial Setup
1. Click Next on the Wizard window. This will take you to the User Permission window.
2. Navigate to the Admin Password input field. Enter the admin password into the Admin Password input field. By
default, the password is 12345.
3. Check the New Admin Password checkbox to change the admin password. Enter the new password and
confirm the password in the given fields.
To Next Page
Loading...
Need help?
General