Honeywell PX940 - External Power Port

10 PX940 Applicator Interface Installation Instructions
External Power Port
External Power Port Pinouts
9 Reserved
10 Ribbon/
Media low
Output Goes LOW when the ribbon/media roll
diameter drops below a predefined level,
otherwise Goes HIGH.
Media low is supported only by I-Style.
11 Verification
failed
Output
Goes LOW when the printer encounters
Verification failed error.
Goes HIGH when the error is cleared.
12 +24VDC Output Power for external devices: +24VDC (±10%)
@2A.
13 +5VDC Power Voltage supply for external sensors.
Configurable for internal or external source.
14 Power
ground
Ground +24VDC return.
Pin Signal Type Description
1 +5VDC Input +5VDc input for distribution through Applicator
Port connector (Z-Style pin 2, S-Style pin 13)
2Signal
ground
Input Signal return for +5VDC supply (Z-Style pin 1,
S-Style pin 2)
3 +24VDC Input
+24VDC input for distribution through Applicator
Port connector (Z-Style pin 7, S-Style pin 12)
4Power
ground
Input
Power return for input (Z-Style pin 8, S-Style pin 2)
5 +24VDC Input
+24VDC input for distribution through Applicator
Port connector (Z-Style pin 7, S-Style pin 12)
Pin Signal Type Description