Honeywell PX940 - Chapter 2 - Set Up the Printer; Power Up the Printer; Chapter 3 - Connect the Printer; Connect the Printer to Your PC

24 PX940 Applicator Interface Installation Instructions
Error Messages
ERRNOAPP
Message:
Operation not allowed. Applicator Port disabled.
Cause:
Application sent an applicator port command to the printer
and the applicator port is disabled.
Error Number:
88
ERRAPP
Message:
Operation not allowed. Applicator Port enabled.
Cause:
Application sent the Fingerprint command PORTOUT(PORT)
ON|OFF on a port used by the applicator port when the
applicator port is enabled.
Error Number:
89
ERRINPUTON
Message:
Operation not allowed in Direct Protocol.
Cause:
Running the PORTOUT.DATAREADY ON|OFF or
PORTIN.<SIGNAL> GOSUB XXX commands when the printer
is using Direct Protocol.
Error Number:
90
EAPPERR1
Message:
Applicator Error 1.
Cause:
AppErr1 in signal detected.
Result:
Activates event in System Health Monitor (SHM).
Error Number:
1340
EAPPERR2
Message:
Applicator Error 2.
Cause:
AppErr2 in signal detected.