16 PX940 Applicator Interface Installation Instructions
5. Click Save. The settings are saved.
Setup Mode
Use the printer touch screen to view and change settings.
1. Press Menu > Settings > System Settings > Manage I/O.
2. Choose Enable from the drop-down list for the applicator.
3. From the menu, select Menu > Settings > Printing > Applicator.
About Applicator Input Signals
This section describes the INPUT signals.
Note: All IN signals are asserted low and de-asserted high.
DC 24V Configures the printer to use either its internal power
supply or an external supply (connected to the External
Power port) to provide +24VDC to the Z-Style and
S-Style ports.
Signal Description
Startprint
Starts a print job. Choose either Level or Pulse.
• Level: The printer starts printing labels when the
startprint signal is asserted and continues printing
until the signal is de-asserted.
• Pulse: The printer prints one label when the startprint
signal is asserted. The startprint signal must be
de-asserted and then asserted to print the next label.
Feed
Feeds a single label. Not supported by S-Style.
Pause
Toggles between Pause mode and printing. Not
supported by S-Style.
Reprint
Reprints the last valid label.
Apperr1
Applicator error 1.
Apperr2
Applicator error 2.
Apperr3
Applicator error 3.
RTWINEXT
External input signal, which you can use to monitor the
operational status of the entire system.
Setting Description
To Next Page
Loading...
