26 PX940 Applicator Interface Installation Instructions
Display Messages
These messages appear in the printer display under certain conditions when a
PRINTFEED command is run.
Message:
APPLICATOR PORT: Wait for signal.
Cause:
Running a PRINTFEED command blocks execution until a
startprint signal is received. The message appears when
execution has been blocked for a few seconds.
Message:
APPLICATOR PORT: Wait for reprint.
Cause:
Running a PRINTFEED -1,1 command blocks execution until a
reprint signal is received. The message appears when execution
has been blocked for a few seconds.
To Next Page
Loading...
