PX940 Applicator Interface Installation Instructions 21
Example:
•...
100 ON PORTIN.REPRINT GOSUB 150
...
150 PRINTFEED -1,1
160 RETURN
Printfeed
The dataready signal must be set manually by the Fingerprint application
before a printfeed is issued when using with an applicator.
Handling External Applicator Errors
When an error signal (apperr1, apperr2, or apperr3) is received, the application
moves to a specified subroutine that takes action based on error severity.
Example
•...
60 ON PORTIN.APPERR1 GOSUB 100
...
100 perform error handling
110 RETURN
Handling Internal System Errors
For internal system errors, the system error signal status can be read at any
time within the application so appropriate measures can be taken. When any of
these errors occur, the appropriate out signal (including the error) is asserted:
• Printhead lifted
• Ribbon out
• Media out
• General print engine fault
•Front arm lifted
• Verifier calibration required
• Verifier calibration expired
• Exceed maximum barcodes
• Verifier hardware error
• Verifier failure action prompt
Example
• 10 IF PORTIN.RIBBONLOW GOTO 200
...
To Next Page
Loading...
