EDA52 User Guide 5
EDA52 computers are designed for use with battery model BAT-EDA52 or EDA52-
BAT-US manufactured for Honeywell International Inc. When ordering a
replacement battery, it is important to order by part number and not only by
model number. See Battery Part Numbers on page 5 for guidance on the correct
battery part number for your unit configuration.
For a list of compatible accessories, see the EDA52 Accessory Guide, available for
download from the product device pages at sps.honeywell.com. Contact your local
sales representative for replacement battery ordering information.
Battery Part Numbers
EDA52 Models
Charge the Battery Before Use
The mobile computer ships with a partially charged battery. Charge the battery
with an EDA52 charging device for a minimum of 3.5 hours.
Note: Using the computer while charging the battery increases the time required to reach
a full charge.
About the USB Type C Connector
On EDA52 models equipped with a USB port, you can use a USB cable to charge
the mobile computer from a host device (e.g., laptop or desktop computer). The
connected host device must supply a minimum power output of 5V, 0.5A to the
mobile computer.
Note: If the mobile computer is drawing more current than supplied by the charging source,
charging will not take place.
Caution: Improper battery replacement or incompatible device usage may
result in risk of burns, fire, explosion, or other hazard. Dispose of
lithium-ion batteries according to local regulations. Risk of fire and
burns if improperly handled. Do not open, crush, heat above 60°C
(140°F), or incinerate.
Battery Model Number Battery Part Number
BAT-EDA52 50172021-001
EDA52-BAT-US 50183310-001
Caution: Read Enable Airplane Mode on page 12 and all cautionary markings
on the battery, charging peripheral, and device using the battery
before attempting to install, use, or charge the battery.
To Next Page
Loading...
Need help?
General
