41
MAN0530 Issue 09 October 03 Searchline Excel
2104M0506
Use a viewing position that ensures that the full circular view is in sight. An ellipse will
appear when slightly off axis.
Off-axis view
Caution: Do not try to adjust the cross-hairs using the telescope's elevation and windage
adjusters as they have been factory set.
Clamp nuts
Mounting bracket
adjusting screw (2 off)
Adjustment clamp
lock screw (2 off)
Pivot block
adjusting screw
(2 off)
Adjustment clamp
lock screw
(2 off)
Clamp nuts
Mounting bracket
adjusting screw (2 off)
Adjustment clamp
lock screw (2 off)
Pivot block
adjusting screw
(2 off)
(6) Iteratively tighten and loosen each pair of adjustment screws sequentially in the
horizontal and vertical directions until the setting is correct.
3. INSTALLATION AND OPERATION
To Next Page
Loading...
