Honeywell Searchline Excel - Page 91

91
MAN0530 Issue 10 - 11/09 Searchline Excel
2104M0506
Initialisation
This starts the initialisation process. The following message is displayed:
Press Enter to
Initialise Unit
This message is displayed during the initialisation process after pressing Enter.
Processing Data
Please Wait
This message is displayed for three seconds at the end of a successful initialisation process.
Unit Initialised
Note: The Searchline Excel system is live after a successful initialisation.
Set Time
This option lets you set the system’s time and date.
The initial display after SET Time is chosen is in the following format:
Time HH:MM
hh:mm
where: hh Hours.
mm Minutes.
Whenrstdisplayedonlythecurrenthourisshown.
All settings are adjusted by means of the and keys on the keypad.
After setting the hour the minutes are displayed.
After the time has been entered then the same process is used to set the date which is displayed
in the following format:
Date DD/MM/YY
dd/mm/yy
where: dd Day.
mm Month.
yy Last two digits of the year.
Notes:
1. The time and date will not be updated unless both are entered and accepted without
error.
2. The year 2000 is displayed as 00.
>
>
>
>
APPENDIX A - HANDHELD INTERROGATOR