Honeywell ST700 - Page 38

Page 24 FOUNDATION Fieldbus ST 700 Pressure Transmitter User's Guide Revision 2.0
Parameter Description
FD_CHECK_PRI Designates the alarming priority of the CHECK_ALM. The valid range is 0-
15.
FD_CHECK_MAP Mapped CHECK_ALM alarm conditions. Corresponds bit for bit to the
CHECK_ACTIVE. A bit on means that the corresponding alarm condition is
Mapped and is detected. A bit off means the corresponding alarm condition
is disabled and is not detected.
FD_CHECK_MASK Mask of CHECK_ALM. It corresponds to the bit of bit to CHECK_ACTIVE. A
bit on means that the condition is masked out from alarming.
FD_CHECK_ACTIVE Enumerated list of check conditions within a device.
FD_CHECK_ALM Alarm indicating check alarms. These conditions do not have a direct impact
on the process or device integrity.
FD_SIMULATE When simulation is enabled, the Field Diagnostics conditions are taken from
Diagnostic Simulate Value, or else the conditions are taken from Diagnostic
Value.
HARDWARE_REV The hardware revision number of the communications module.
SOFTWARE_REV The software revision number of the communications module.
MODEL_KEY The key number of ST 700 pressure transmitter (Example: STD 810).
MOD_PART_1 First part of the Material of Construction Information.
MOD_PART_2 Second part of the Material of Construction Information.
MOD_PART_3 Third part of the Material of Construction Information.
MOD_PART_4 Fourth part of the Material of Construction Information.
HW_SIMULATE_JUM
PER_STATE
State of Hardware Simulation Jumper (Enabled / Disabled).
INSTALL_DATE The date and time when the device is installed in the field. The date and
time is directly acquired from the FF Host.
MAINTENANCE_MO
DE
It indicates whether device is ready for maintenance.'Chk with Oper'- Check
with operator to determine availability. ‘Avail for Maint'- The device is
available for maintenance.
Attributes
Supported Modes The block supports the following modes:
• AUTO (Automatic)
• IMAN (Manual)
• OOS (Out of Service).
Alarm Types The block supports standard block alarms (see section 3.2), and
added to it, a discrete alarm for write lock.