Honeywell STT750 SmartLine - Editing a Numeric Value; Selecting a New Setting from a List of Choices; Table 6 - Three-Button Data Entry

Page 22 STT750 Temperature Transmitter User’s Manual Revision 4
Table 6 – Three-Button Data Entry
Screen
Symbol
Numeric data entry
Text entry
H
Display the high limit for this parameter.
This symbol only appears in the left-most
position of the data entry field.
Not Available
L
Display the low limit for this parameter.
This symbol only appears in the left-most
position of the data entry field.
Not Available
<<
Terminate the numeric entry
Terminate the text entry
0 thru 9,
Minus,
Decimal
These characters are used to enter
numeric values. The minus sign only
appears in the left-most digit.
These characters can be used to
create custom tags and unit labels
A thru Z,
0 thru 9
special
symbols
Not Available
These characters can be used to
create custom tags and unit labels
4.2.3. Editing a Numeric Value
Editing a Numeric Value
Editing of a numeric value is a digit-by-digit process, starting with the left-most digit.
1. Press  to begin the edit process.
2. The Display will show the current value of the item on the lower line, left justified.
3. Press the  or  buttons to select the desired digit, and then press  to advance to the next
digit to the right.
4. After the last digit has been entered, press  one more time to write the new value to the
transmitter.
4.2.4. Selecting a new setting from a list of choices
Use the procedure described below to select a new setting for parameters that present a list of choices
(e.g., Screen PV, Screen Units, etc.).
1. Press  to begin the edit process.
a. The Display will show the current setting of the item on the lower line, left justified.
2. Press the  or  buttons to scroll through the list of choices.
3. Press  to make your selection. The new selection will be stored in the transmitter and will
be displayed on the lower line, right justified.