Honeywell STT750 SmartLine - Table 7 - the Display Menus; The Display Menu

Revision 4 STT750 Temperature Transmitter User’s Manual Page 23
4.2.5. The Display Menu
Table 7 – The Display Menus
'#' in "Screen #" indicates the screen numbers 1, 2, 3, 4, 5, 6, 7, 8
LCD Contrast
»»»»»
Adjust the LCD contrast level.
Range from » (1) to »»»»»»»»»
(9)
Default: »»»»»»» (7)
Press ↵ to
enter menu
selection
↑ and ↓ to
select entry.
↵ to enter
Rotation Time
Screen Rotate
Enabled
Disabled
Select to enable or disable the
automatic rotation of Screens
Select Screen
1 through 8
Select Screen to configure.
Screen #
Enabled/Disabled
Select to enable or disable the
screen for display and configuration
Screen # PV
Loop PV
CJ Temperature
Sensor
Resistance
Loop Output
Percent Output
Select the Process Variable (PV)
that will be shown on the screen.
Sensor Resistance is only available
for RTDs and will read 0 for
thermocouples
Screen # Decimal
None
Select the PV decimal resolution to
be shown on selected screen from
list.
X.X
X.XX
X.XXX
Screen # Units
(Writable only for
TC/RTD sensor types
only)
°C, °F,°R, K
Choose appropriate engineering
units from list
Range/Cal Units
(Visible for TC and
RTD sensor type only)
°C, °F, °R, K
Select the ranging and calibration
temperature units
Sensor Type
(Database updates
take 30 seconds to
complete. Do not
interrupt power).
mV, TC, RTD,
Ohm
Select Sensor Type.
Sensor ID
(Database updates
take 30 seconds to
complete. Do not
interrupt power).
Sensor Identifier
Select Sensor ID for Input selected
Sensor Type (Input selection).
Sensor Wire Type
(Visible for RTD and
Ohm sensor type only)
2-Wire, 3-Wire, 4-
Wire
Select the number of lead wires for
RTD and Ohm sensors.
Sensor Lead Resist
(Visible for RTD and
Ohm sensor type only)
####.##
Sensor lead wire resistance value.
(only if RTD type is 2 wire)
Sensor Bias
####.##
Bias on the measured value