TL8230A1003
1
Read the entire document
CAUTION:
•Installation must be carried out by a certified electrician and must comply with national and local
electrical codes.
•To prevent severe shock or electrocution, always cut the power at the service panel before working
with wiring.
•Use this thermostat for resistive loads only.
•Do NOT install the thermostat in an area where it can be exposed to water or rain.
• Avoid locations where there are air drafts (top of staircase, air outlet), dead air spots (behind a
door), direct sunlight or concealed chimney or stove pipes.
•For a new installation, choose a location about 5 ft. (1.5 m) above the floor.
•Install the thermostat on an inside wall facing the heating system.
•Install the thermostat onto an electrical box.
•Use special CO/ALR solderless connectors if you connect the thermostat to aluminum wires.
•Keep the thermostat's top and bottom air vents (openings) clean and unobstructed at all times.
Before you start
69-1803ES-03.book Page 1 Friday, March 1, 2013 10:13 AM
To Next Page
Loading...
Need help?
General
