Refer to the table of compatible devices at the back of this manual.
Supervised transmitters† send check-in signals to the receiver at 70-90 minute intervals. If
at least one check-in message is not received from each transmitter within a 12-hour period,
the “missing” transmitter number(s) and “CHECK XX” is displayed. († Hand-held
transmitters, e.g., 5834, 5834EN, do not send check-in signals.)
To be sure reception of the transmitter's signal at the proposed mounting location is
adequate, perform a Go/No Go Test, described in the Testing the System section.
Install transmitters in accordance with the instructions provided with each.
Set 5828, wireless keypads to the programmed House ID (field *24), using the instructions
provided with the device.
Use *56 or *58 Zone Programming Menu modes to program zone information and enroll
transmitters (VISTA-20P: zones 9-48, buttons 49-64; VISTA-15P: zones 9-34, buttons 49-
56).
Wireless Keys: Use Wireless Key Programming Templates section of the *58 Zone
Programming Menu mode to program zone information and enroll each button of the
wireless keys used. Once a wireless key is enrolled, it must be assigned to a user before it
becomes active. See Adding/Deleting Security Codes section for procedure.
The RF supervision period for the VISTA-20PCN and VISTA-15PCN is three hours for Fire zones
(Zone Type 9 and 16) and 12 hours for all other zone types.
UL
The following transmitters are not intended for use in UL installations: 5802WXT, 5802WXT-2,
5834, 5814, 5819, 5819WHS & BRS, and 5853.
• See Wireless Transmitter paragraph in the Limitations of This Alarm System statement
located at the end of this manual for information on transmitter battery life.
• Button-type transmitters (such as 5802WXT 5802WXT-2) should be periodically tested for
battery life.
Do not install batteries in wireless transmitters until you are ready to enroll during system
programming. After enrolling, batteries need not be removed.
To Next Page
Loading...
