Honeywell VISTA-15P - Panic Keys; Setting the Clock

VISTA-15P/20P/SIA Installation and Setup Guide
19
System Communication and Operation (Continued)
SUMMARY OF ARMING MODES
Arming Mode
Features for Each Arming Mode
Exit Delay
Entry Delay
Perimeter Armed
Interior Armed
AWAY
Yes
Yes
Yes
Yes
STAY
Yes
Yes
Yes
No
NIGHT-STAY
Yes
Yes
Yes
only those zones
listed in Night-Stay
zone list
INSTANT
Yes
No
Yes
No
MAXIMUM
Yes
No
Yes
Yes
Panic Keys
There are three Panic keys (A, B, and C) that, if programmed, can be used to manually initiate alarms and send a
report to the central station.
Each key can be programmed for 24-hour Silent, 24-hour Audible, Fire, or Personal Emergency responses.
The programmed Panic response is activated when the appropriate key is pressed for at least 2 seconds.
The Panic keys are identified by the system as follows:
Keys
Displayed as Zone
[A] (/1)
95
[B] (/#)
99
[C] (3/#)
96
IMPORTANT: For a Silent panic function (if programmed) to be of practical value, you must program a report
code for the zone and the system must be connected to a central station.
Setting the Clock
IMPORTANT: The Real-Time Clock must be set before the end of the installation.
NOTE: All partitions must be disarmed before time/date can be set.
Set the time and date by doing the following:
1. +[#] + [6] [3]
(Master Code)
Alpha Display:
DISARMED
READY TO ARM
2. Press [] when the time/date is displayed.
A cursor appears under the first digit of the hour.
To move cursor ahead, press [  ]. To go back, press [#].
 Enter the 2-digit hour setting.
 Enter the 2-digit minute setting.
 Press [1] for PM or [2] for AM.
 Enter the last two digits of the current year.
 Enter the 2-digit month setting.
 Enter the 2-digit day setting.
3. To exit, press [] when cursor is at the last digit. If you wait and let it
timeout, it will not save any changes.
TIME/DATE SAT
04:04PM 10/17/00
Current time display
TIME/DATE SAT
04:04P2000/10/17
Time/date editing display