VISTA-15P/20P/SIA Installation and Setup Guide
3
Mounting and Wiring the Control (Continued)
Installing the Control Cabinet and PC Board
1. Remove the cabinet door. Remove
the cabinet knockouts needed for
wiring entry.
2. Mount the control cabinet to a sturdy
wall in a clean, dry area, which is not
readily accessible to the general
public, using fasteners or anchors
(not supplied) with the four cabinet
mounting holes.
3. When installation and wiring is
completed, install the cabinet door
and secure by using 2 screws
(supplied) through the door's edge.
OPTIONAL KEY LOCK: If desired, a
key lock can be installed (K4445V1).
Remove the lock knockout from the
door. Insert the key into the lock.
Position the lock in the hole, making
certain that the latch will make contact
with the latch bracket when the door is
closed. When correctly positioned, push
the lock until the snap tabs hold it
securely.
Figure 1. Installing the Door and Cabinet Lock
Mounting the PC Board
Alone (no RF Receiver)
Before installing the cabinet's contents, remove the metal cabinet knockouts required for
wiring entry. Do not remove the knockouts after the circuit board has been installed.
1. Hang two short mounting clips (provided) on the raised cabinet tabs (see Detail B).
2. a. Insert the top of the circuit board into the slots at the top of the cabinet. Make sure that
the board rests on the correct row (see Detail A).
b. Swing the base of the board into the mounting clips and secure the board to the cabinet
with the accompanying screws (see Detail B).
Figure 2. Mounting the PC Board
Mounting Board with RF
Receiver
Do not mount the cabinet on or near metal objects. This will decrease RF range and/or block RF
transmissions from wireless transmitters.
Do not locate the cabinet in an area of high RF interference (revealed by frequent or prolonged lighting
of the LED in the receiver (random flicker is OK)
1. a. Remove the receiver board from its case, then insert the top of the board into the slots at the top of
the cabinet, as shown in Detail A in Figure 3 on the next page. Make sure that the board rests on
the correct row of tabs.
b. Swing the base of the board into the mounting clips and secure it to the cabinet with the
accompanying screws.
c. Insert the top of the control's board into the slot in the clips and position two clips at the lower edge
of the board.
d. Swing this board into place and secure it with two additional screws.
2. Insert grounding lugs (supplied with the receiver) through the top of the cabinet into the
left-hand terminals of the antenna blocks (at the upper edge of the receiver board) and
secure them to the cabinet top with the screws provided (see Detail B).
3. Insert the receiver's antennas through the top of the cabinet, into the blocks' right-hand
terminals, and tighten the screws.
2. Insert grounding lugs (supplied with the receiver) through the top of the cabinet into the
left-hand terminals of the antenna blocks (at the upper edge of the receiver board) and
secure them to the cabinet top with the screws provided (see Detail B).
To Next Page
Loading...
