– 32 –
7. Select the Region from the Region drop-down menu and enter the
appropriate ZIP or Postal code.
8. A choice (checkmark = Yes; X = No) to copy the time to the control panel
may appear. “Yes” sets the control panel to the time entered in VAM.
Setting a Static Network Address.
1. Click Setup > Network to review the current Local Area WiFi Network
Connection page to review the ip address. The default option is DHCP
2. Select the Connection Type as Static IP and replace the displayed
IP address with the recommended network information.
3. At the “Save Success?” prompt, click the checkmark (yes).
Options and ECP Address (for Installer use only)
IMPORTANT: The Options menu is intended for the installer only and the
settings should not be changed by the user. Changing these settings can
disconnect communication between VAM and the control panel and cause
system errors.
User Profile
This page collects the user’s data. The page data entries are as follows:
NOTES:
• This page can be accessed from the home page by pressing Setup >
User Profile
• The data for Region and Zip Code/Postal Code synchronizes to the
Time/Date setup page if completed during the initial setup. The e-mail
address synchronizes to the e-mail setup page, if completed during the
initial setup.
• The Zip Code option is needed for accessing daylight savings time for
your Z-Wave scenes
To Next Page
Loading...
