– 5 –
Navigating the VAM Menus
VAM is controlled by using a web browser on a Wi-Fi enabled smart device.
Your installer will have shown you the URL to enter into the browser’s
address bar that opens VAM’s Main menu, and perhaps made a bookmark
(favorite) for easy access later. If not, you can locate VAM by going to:
http://vam.mylanconnect.com.
Navigation begins from the Main menu. Navigate through various sub-menus
by clicking graphical buttons (buttons) to perform a selected function.
From the Main menu you can:
• control your security system
• control/view your cameras
• control home automation such as
lighting, thermostat, water valves
garage door openers, shades and
door locks
• switch from PC view to mobile
view by clicking Switch Theme
button.
• go to advanced setup menus.
NOTE: Depending on the type of device being used to access the VAM,
options are selected by either clicking a mouse pointer or
touching/tapping the screen. In this manual, the term “click” is used
to indicate this function.
Memory Card
The VAM supports automatic software
upgrades. However, an SD memory card must
be installed and left in the VAM to upgrade
the software. Your installer may have installed
the SD memory card for you. See Software
Upgrades section later in this manual for more
information about automatic software
upgrades.
If not already installed, insert the memory
card (SD/SDHC Card) as shown.
• 4GB SD card supplied
• Supports up to 16GB SD Card
IMPORTANT: Avoid touching the contacts
To Next Page
Loading...
