– 22 –
Groups and rooms are defined collections of Z-Wave devices that can be used
in scenes.
A group is a defined collection of the same type of Z-Wave devices (only light
modules, or only door locks, etc.). When used in a scene and the scene activates,
all devices assigned to that group activate.
A room is a defined collection of different types of Z-Wave devices (light
modules, door locks, thermostat, etc.). Defining rooms can help organize your
devices to make it easier to locate specific devices you may wish to control.
Steps to Create a Group
1. Click Automation > Group Setup .
2. Click the Add button and enter a group name > GO.
3. Choose the Group Type (Binary Switches, Dimmer Lights, Door Locks,
Shades, Thermostats, Garage Doors, Water Valves, and Others) from the
drop-down list.
4. Choose the device(s) to be part of this group from the drop-down list.
Use the edit button to change the name of a group if desired.
5. Click Save.
Steps to Create a Room
1. Click Automation > Room Setup
.
2. Click the Add button and enter a room name > GO.
3. Select the device(s) to be part of this room from the drop-down list.
4. Click Save.
Using the Security System (Security Menu)
You can control your security system using VAM’s Security menu, including
arming, disarming, and bypassing zones. Refer to the control panel’s user
guide for details on specific security system functions.
User Codes
Each user was assigned a name and 4-digit user code by your installer at the
time of installation. To add additional user codes, refer to your security
system user guide.
Introduction to Arming and Disarming the System
To Next Page
Loading...
