Honeywell Vocollect - Charging a T1 Battery in a Device; Charging a T1 Battery in a T1 10-Bay Combination Charger; Charging a T1 Battery with a T1 Single Charger Cable; Removing a T1 Device from a T1 10-Bay Combination Charger

| Talkman T1 | 143
Battery Notifications
Battery warnings for a Talkman battery occur at the following levels:
• First warning = 3,550 mV
• Critical warning = 3,350 mV
Charging a T1 Battery in a Device
1.
Remove the device from the holster.
2.
Disconnect the headset from the device.
3.
Insert the device into an open slot on the charger.
4.
After the device has been placed into the charger, make sure that the LED indicator on the device turns on and is
green.
a) If the LED does not turn on after 30 seconds, remove the device from the charger slot and then place it into the
slot again.
b) If the LED indicator still does not turn on, try another charger slot.
CAUTION: Do not attempt to place the device into the charger unless you have first disconnected the
headset.
Charging a T1 Battery in a T1 10-Bay Combination Charger
1.
Remove the battery from the Talkman device.
2.
Hold the battery with its contacts to the top and facing away from you.
3.
Place the battery into an open battery slot on the front of the charger.
Charging a T1 Battery with a T1 Single Charger Cable
1.
Grasp and squeeze the sides of the I/O connector on the cable.
2.
Attach the I/O connector onto the T1's connectors and release the I/O connector. Ensure the flush side of the I/O
connector faces front with the device’s front.
3.
Insert the other end of the charging cable into the barrel jack on the plug cable.
4.
Plug the charger into an electrical outlet.
Removing a T1 Device From a T1 10-Bay Combination Charger
Note: The device is ready to use when the LED indicator on the device is green. If the LED is amber, the
device is not ready to be used.
Important: If a device displays a solid red light, contact your system administrator.
1.
Make sure that the device is ready to use.
2.
Pull up on the device to remove it from the device charger.
Disconnecting a T1 Device from a T1 Single Charger Cable
Note: The device is ready to use when the LED indicator on the device is green. If the LED is amber, the
device is not ready to be used.
Important: If a device's LED continuously displays red, contact your system administrator.
1.
Unplug the charger from the electrical outlet.
2.
Gently remove it from the T1 device by squeezing the sides of the I/O connector on the cable. Do not pull the
cable wire.