| Talkman A700 | 56
The Claw Mount is also clamped to a stationary surface,
but can be clamped to oddly-shaped or horizontal or
vertical surfaces.
Figure 6: Claw Mounting Parts
Figure 7: Claw Mounting
Talkman VMT Parts and Accessories
The following device-mounting options are supplied by Honeywell. Order one part from each line for your
configuration.
Table 1 describes items that support Talkman VMT configurations. Several electrical components are common for
both Talkman A500 and Talkman A700 configurations.
Table 2 describes battery-powered configurations. Battery-powered configurations enable you to safely mount the
Talkman device without interfacing with the vehicle’s electrical system. Batteries and chargers are required to support
these configurations.
Table 1: Vehicle-Powered Vehicle Mount Configurations
A500 A700
BL-710-1 - VEHICLE MOUNT, HOLDER,
TALKMAN(R) T5 SERIES
BL-904 - POWERED VEHICLE DOCK, A700
SERIES
BL-710-101 - VEHICLE MOUNT, HOLDER/BASE
SCREW ON ATTACHMENT, TALKMAN(R) T5
SERIES (connects between Talkman device mount
and mount arm)
BL-710-101 - VEHICLE MOUNT, HOLDER/BASE
SCREW ON ATTACHMENT, TALKMAN(R) T5
SERIES (connects between Talkman device mount
and mount arm)
BL-710-102 - VEHICLE MOUNT, ARM,
TALKMAN(R) T5 SERIES
BL-710-102 - VEHICLE MOUNT, ARM,
TALKMAN(R) T5 SERIES
To Next Page