11 - 8
Scanner-Bioptic ACK/NAK Mode *Bioptic ACK/NAK Off 232NAK0 2-23
Bioptic ACK/NAK On 232NAK1 2-23
Scanner-Bioptic ACK/NAK Timeout ACK/NAK Timeout
*5100
232DLK##### 2-23
Input/Output Selections
Power Up Beeper Power Up Beeper Off - Scanner BEPPWR0 3-1
*Power Up Beeper On - Scanner BEPPWR1 3-1
Beep on BEL Character Beep on BEL On BELBEP1 3-1
*Beep on BEL Off BELBEP0 3-1
Trigger Click On BEPTRG1 3-1
*Off BEPTRG0 3-1
Beeper - Good Read Off BEPBEP0 3-2
*On BEPBEP1 3-2
Beeper Volume - Good Read Off BEPLVL0 3-2
Low BEPLVL1 3-2
Medium BEPLVL2 3-2
*High BEPLVL3 3-2
Beeper Pitch - Good Read
(Frequency)
Low (1600) (min 400Hz) BEPFQ11600 3-2
*Medium (2700) BEPFQ12700 3-2
High (4200) (max 9000Hz) BEPFQ14200 3-2
Beeper Pitch - Error (Frequency) *Razz (250) (min 200Hz) BEPFQ2250 3-3
Medium (3250) BEPFQ23250 3-3
High (4200) (max 9000Hz) BEPFQ24200 3-3
Beeper Duration - Good Read *Normal Beep BEPBIP0 3-3
Short Beep BEPBIP1 3-3
LED - Good Read Off BEPLED0 3-3
*On BEPLED1 3-3
Number of Beeps - Error *1 BEPERR1 3-4
Range 1 - 9 BEPERR# 3-4
Number of Beeps - Good Read *1 BEPRPT1 3-4
Range 1 - 9 BEPRPT# 3-4
Good Read Delay *No Delay DLYGRD0 3-4
Short Delay (500 ms) DLYGRD500 3-4
Medium Delay (1000 ms) DLYGRD1000 3-4
Long Delay (1500 ms) DLYGRD1500 3-4
User-Specified Good Read Delay Range 0 - 30,000 ms DLYGRD##### 3-4
Manual Trigger Modes *Manual Trigger - Normal PAPHHF 3-5
Manual Trigger - Enhanced PAPHHS 3-5
LED Illumination - Manual Trigger Off PWRNOL0 3-5
Low PWRNOL100 3-5
*High PWRNOL150 3-5
Serial Trigger Mode Read Time-Out
(0 - 300,000 ms) *30,000
TRGSTO#### 3-5
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page
To Next Page
Loading...
