3 - 9
Streaming Presentation™ Mode
When in Streaming Presentation mode, the scanner’s aimer goes out after a short time, but the scan illumination remains on all
the time to continuously search for bar codes. Two modes are available, Normal and Enhanced. Normal mode offers good
scan speed and the longest working ranges (depth of field). Enhanced mode will give you the highest possible scan speed but
slightly less range than Normal mode. Enhanced mode is best used when you require a very fast scan speed and don’t require
a long working range.
When using Preferred Symbology (page 3-15), a lower priority symbol must be centered on the aiming pattern to be read in
Streaming Presentation Mode.
Mobile Phone Read Mode
When this mode is selected, your scanner is optimized to read bar codes from mobile phone or other LED displays. However,
the speed of scanning printed bar codes may be slightly lower when this mode is enabled. You can enable Mobile Phone Read-
ing for either a hand held device, or for a hands-free (presentation) application.
Note: To turn off Mobile Phone Read Mode, scan a Manual or Serial Trigger Mode bar code (see page 3-5).
Hands-Free Time-Out
The Presentation Mode is referred to as “hands-free” mode. If the scanner’s button is pushed when using a hands-free mode,
the scanner changes to manual trigger mode. You can set the time the scanner should remain in manual trigger mode by set-
ting the Hands-Free Time-Out. Once the time-out value is reached, (if there have been no further button pushes) the scanner
reverts to the original hands-free mode.
Scan the Hands-Free Time-Out bar code, then scan the time-out duration (from 0-300,000 milliseconds) from the inside back
cover, and Save. Default = 5,000 ms.
Streaming Presentation Mode
- Normal
Streaming Presentation Mode
- Enhanced
Hand Held Scanning - Mobile
Phone
Streaming Presentation -
Mobile Phone
To Next Page
Loading...
