Honeywell Vuquest 3330g - Datalogic Magellan © Aux Port Configuration; NCR Bioptic Aux Port Configuration; Wincor Nixdorf Terminal Default Settings

2 - 5
Datalogic™ Magellan
©
Aux Port Configuration
Scan the following Plug and Play code to program the scanner for a Datalogic Magellan auxiliary port configuration. This
bar code sets the baud rate to 9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the Activate Defaults bar code on page 1-4
first, then scan the programming code above.
NCR Bioptic Aux Port Configuration
Scan the following Plug and Play code to program the scanner for an NCR bioptic scanner auxiliary port configuration. The
communication should be set at 9600bps baud rate, 7 data bit data format, even parity and 1 stop bit. The following prefixes
are programmed for each symbology:
Note: If you are having unexpected results with this programming code, scan the Activate Defaults bar code on page 1-4
first, then scan the programming code above.
Wincor Nixdorf Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf terminal. This bar code sets the baud
rate to 9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the Activate Defaults bar code on page 1-4
first, then scan the programming code above.
Symbology Prefix Symbology Prefix
UPC-A A Interleaved 2 of 5 b
UPC-E E0 Code 128 f
GS1 DataBar
Omnidirectional
r
EAN-8 FF GS1 DataBar
Expanded
r
EAN-13 F Codabar N
Code 39 a Code 32
Pharmaceutical
(PARAF)
a
Datalogic Magellan Bioptic Settings
NCR Bioptic Settings
Wincor Nixdorf Terminal Settings