Xenon/Granit User Guide 91
Page Button with Scanner in the Base
When the scanner is in the base, press the page button on the base to begin
Streaming Presentation Mode. The scanner acts as a presentation scanner for 10
seconds. If a bar code is scanned before the 10 second timeout is reached, the
timer starts over. Lift the scanner from the base to return to manual triggering. To
change the timeout from 10 seconds see Temporary Streaming Presentation
Timeout on page 91.
Temporary Streaming Presentation Timeout
Set a timeout for the length of time the illumination remains on and searching for
bar codes when using Temporary Streaming Presentation Mode. Set the length for
the timeout by scanning one of the bar codes below. Default = 10,000 ms (10 sec-
onds).
See Paging, below, for further information about Page Button settings.
Scan While in Base Cradle
If you want to be able to scan bar codes while the scanner is in the base cradle,
scan the Scan in Cradle On bar code below. If you want to only allow scanning
when the scanner is out of the base cradle, scan Scan in Cradle Off. If you want the
scanner to shut down when in the base cradle, scan Shut Down Scanner in Cradle.
Default = Scan in Cradle On.
To Next Page
Loading...
