108 Xenon/Granit User Guide
Auto Reconnect Mode
Auto Reconnect controls whether or not the scanner automatically begins the
relink process when a loss of connection is detected. When the Auto Reconnect On
bar code is scanned, the scanner begins the relink process immediately, without
user intervention. Default = Auto Reconnect On.
The table below shows the results of the Auto Reconnect On and Off settings:
Maximum Link Attempts
The Maximum Link Attempts setting controls the number of times the scanner
tries to form a connection with a base. During the connection setup process, the
scanner transmits in order to search for and connect to a base. In order to prevent
continuous transmissions that could interfere with other users of the ISM band,
the number of attempts to connect is limited by this setting. After the maximum
Event Auto Reconnect On Auto Reconnect Off
Scanner out of range Relink occurs automatically. If
maximum number of link attempts
is unsuccessful, then the scanner
must be relinked by either pulling
the trigger or placing the scanner
in the base. (See Maximum Link
Attempts on page 108.)
The scanner is relinked by
pulling the trigger.
Base reset (firmware
upgrade or power cycle)
Scanner behaves as if out of range. No attempt to relink made
while base is powered off.
Trigger must be pulled to
initiate relinking.
Scanner power down due to
Power Time-Out Timer
setting
Trigger must be pulled or the scanner must be placed in the base unit
to relink.
(Note: scanner relinks on power up, but powers on due to one of the
above actions.)
Scanner reset due to
firmware upgrade
Relink occurs automatically.
Scanner reset due to instant
charge pack change
Relink occurs automatically.
Scanner placed in different
base unit
Relink to new base occurs automatically.
To Next Page
Loading...
