Honeywell XYR 5000 Series - 1: Selecting the Normal Sampling Rate from the Transmitter; 2: Configure the Normal Sampling Rate Using WMT

Honeywell Process Solutions Wireless Dual Analog Input Interface Transmitter
24 User Manual Rev. 8
July 2012
Follow the menu map below.
6.2.1: Selecting the Normal
Sampling Rate from the Transmit-
ter*
Figure 6.5: Menu Map to Normal Sampling Rate Setting
NOTE
Once the WMT has been used to configure the
Transmitter, this menu option will be disabled on
the Transmitter LCD Menu.
6.2.2: Configure the Normal
Sampling Rate with WMT
1. Open the configuration dialog box (See Appendix A).
2. In the configuration dialog box click the Sampling Rates tab to display
the sampling rate information as shown below.
3. Select one of the time periods from the Normal Sampling drop-down
list box.
4. Click OK to save and download the configuration changes to the Trans-
mitter.
Figure 6.6: Sampling Rates Tab
* Indicates that Menu is Disabled if Wireless Management Toolkit is detected. (See Appendix A)