Honeywell Process Solutions Wireless Dual Analog Input Interface Transmitter
Rev. 8 User Manual 45
July 2012
Appendix A: Navigating User Menus
Pressing either the NEXT or ENTER buttons located on the front of the
Transmitter or Base Radio just below the Liquid Crystal Display (LCD)
screen is all that is needed to navigate the respective menus. Pressing both
of these buttons for one second will turn the unit on.
Pressing the NEXT button at any time while the Transmitter is cycling
through the normal messages causes the Transmitter to enter the setup
mode. The NEXT button is then used to step through menu options, and
the ENTER button is used to enter a sub menu of what is displayed on the
LCD at that time. If no button is pressed within a 30 second period the unit
goes back to the normal display mode.
If you enter a sub menu that requires a numerical input, such as 001, the
left most 0 will be blinking. This indicates that pressing the NEXT button
will increment this value with each press from 0 to 9 and back to 0 again.
Pressing the ENTER button will move to the next available value. If the
last value is blinking, pressing ENTER will save the entered values and
return from the sub menu.
If both the NEXT and ENTER buttons are depressed at once, a message
on the LCD displaying OFF? will appear. If both buttons are released
upon appearance of this message the user will be returned to the scrolling
main screen. If both buttons are not released for the duration of the OFF?
message the unit will power down and turn off. Note: If the unit is turned
off while entering values in a sub menu, those values will NOT be saved.
* As shown throughout the document, this mark indicates that these menu
options will automatically turn off if the Wireless Management Toolkit
Software is used. All changes to these Transmitter menu options should be
made through software instead. This is to prevent simultaneous changes
from taking place. If you wish to discontinue use of the software and want
these menus re-instated, you must contact your Honeywell Sales Repre-
sentative.
To Next Page
Loading...
