Hoover UH72405 User Manual

12
CYCLONIC FILTER ASSEMBLY: How to Clean
4.11
4.12
Remove dirt cup as described in Fig. 4.5.
4.11 Lift the filter assembly (A) up out of the dirt cup.
4.12 Dirt and debris can be cleaned from the filter
assembly with the dusting/ upholstery tool.
4.13 Place the filter assembly (A) in the dirt cup,
aligning the D-shaped tab on the top of the dirt cup.
Press down firmly to place the filter assembly back
in place. Replace dirt cup lid.
Replace dirt cup as described in Fig. 4.4.
A
A
4.13
BRUSHROLL: How to Clean
4.14 Turn vacuum over so bottom side is facing up.
Remove any debris and/or hair from brushroll.
For additional maintenance required for belt or
brushroll please contact a HOOVER
®
service provider
at 1-800-944-9200.
4.15 Vacuum is equipped with an automatic
brushroll shut off in event of overload or jam.
4.16 To reset the brushroll, press the ON/OFF
Brushroll switch OFF. Then press the ON/OFF
Brushroll switch again to ON. After resetting the
brushroll may still be blocked. Check for obstructions
in the brushroll area and remove any obstructions.
4.14
4.15
4.16
CAUTION
! !
To reduce the risk of injury from moving parts
- Unplug before servicing.
To reduce the risk of personal injury - Unplug
before cleaning or servicing.
WARNING
! !

Hoover UH72405 Specifications

General

Style	upright vacuums
Color	silver
Floor Type	bare floor, carpet, ceramic tile, concrete, hardwoods, laminate, marble
Cord Length	30 feet
Filter	hepa media
Washable Filter	yes
Hypoallergenic	no
Brush Roll Shut-Off	yes
Bagless	yes
Wet And Dry Cleaning	no
?leaning Area	12.5 inches
Brushes and Accessories	yes
Current	11 amperes

Weight and Dimensions

Length	12.5 inches
Height	44.2 inches
Width	14.5 inches
Net Weight	13 pounds