HOTA D6 Pro - Charging Process

Working Parameters Display
Operation and Setup
Charging
1
4
2
5
3
6
Operation Time
Capacity Charged
Battery
Type- string
Number Current
Task Status
Present
Current
Current
Total Battery
Voltage
Cell Voltage
Device Name Completion
Percentage
Current Channel
14
D6 Pro AC/DC Dual Channel Smart Charger
Charging Status Simple Operation
1. Connect power supply to the AC or DC port of the charger, wait for the system
to complete the self-checking. connect the battery to the charger in the standby interface;
2. After select the corresponding channel，short press the speed shuttle key to pop up
the“Task Settings”menu, set the task to“Charge”, adjust the task parameters, and short
press the speed shuttle key to start the task;
Scroll the speed shuttle key during operation can switch the display information in the lower half of the
screen, which are cell voltage, cell internal resistance and run data，the cell voltage and internal resistance
can only be displayed in the mode of balance charging（2 minutes）.
3. When the charge task is executing，short press the speed shuttle key to pop up the“Adjust
Task”menu, will adjust the charge current，long press the CH key can stop the current task；
4. Enjoy.