CAm
AND
CLEAN~G
(continued)
Oven Light Bulb
The light bulb is located on the
back
wall of
the
oven. Before
replacing
the
bulb, disconnect
electrical power to the range at
the
mtiin
fuse
or circuit breaker
panel
or
unp]ug
the
range
from the
electrical outlet. Let the bulb cool
completely
before
removing it.
l’or
your safety, do not touch a
hot bulb with a damp
cioth.
If
you do, the bulb will break.
To remove: Unscrew the cover
and remove the bulb.
To replace: Put in a new 40-watt
o
Socket
t
‘<K>,~
3<in~he~ Ma.
Length
appliance bulb.
NOTE:
Bulb
s
‘(
b
\
● A 40-watt appliance bulb is
‘\
smaller than a standard 40-watt
household
bulb.
We recommend
m
/ ;::,;
,i~j::
Glass Cover .,-.
you use
an
appliance bulb that is
no longer than 3
Y2
inches.
●
Install and tighten the cover.
● Reconnect electrical power to
DO NOT REMOVE SCREWS.
the range.
Oven Vent Duct
Your range is vented through a duct located under the
NOTE: Never cover the hole in the oven vent duct
right rear surface unit.
with aluminum foil or any other material. This
prevents the oven vent from working properly during
any cooking cycle.
Broiler Pan & Rack
After broiling, remove the
If food has burned on, sprinkle the
broiler
pan
from
the oven.
rack while hot with detergent and
Remove
the
rack
from
the pan.
cover with wet paper towels or a
Carefully pour out the grease in the
dishcloth. Burned-on foods
r’
pan into-a-proper
container.
Wash
will soak loose while the
meal
is
and
rinse the pan and rack in hot,
being served.
Do not store
a
soiled broiler pan
S():Lpy
water.
and rack in the oven.
Do not clean in self-cleaning oven.
Oven Shelves
Clean the shelves by hand using soap
The oven shelves may be cleaned in
and
wuter
or with an abrasive
the self-cleaning oven but they will
cleanser. After cleaning, rinse the
become hard to slide and
shelves with clean
wat~r
and dry.
permanently discolor from the heat
To remove heavy, burned-on soil,
and lose some luster. See the
you may use scouring pads. After
Operating the Self-Cleaning
scrubbing,
wash
with soapy water,
Oven section.
rinse
tind
dry.
Metal Parts
Do
not use steel wool, abrasives, ammonia or commercial oven
cleaners. To safely clean surfaces; wash, rinse and then dry with a
soft cloth.
26
To Next Page
Loading...
