How do I fix scale buildup in my HotSpring HIGHLIFE ENVOY Hot Tub?
Scale buildup in your HotSpring Hot Tub is usually due to high calcium content in the water, along with high total alkalinity and pH. To resolve this: * Adjust the total alkalinity and pH. * If scale removal is required, drain the spa, scrub off the scale, refill it, and balance the water.
What causes stains in my HotSpring HIGHLIFE ENVOY Hot Tub and how to remove them?
Stains in your HotSpring Hot Tub can be caused by low total alkalinity or pH, or high iron or copper in the water. To address this: * Adjust the total alkalinity and/or pH. * Use a metal deposit inhibitor.
How do I remove organic buildup or scum from my HotSpring Hot Tub?
Organic buildup or a scum ring around your HotSpring Hot Tub is typically caused by a buildup of oils and dirt. Wipe off the scum with a clean rag. If it's severe, drain the spa, use a spa surface and tile cleaner to remove the scum, and then refill the spa.
What to do if my HotSpring HIGHLIFE ENVOY has a musty odor?
A musty odor in your HotSpring Hot Tub indicates bacteria or algae growth. Shock the spa with sanitizer. If the problem is visible or persistent, drain, clean, and refill the spa.
What causes eye irritation in my HotSpring HIGHLIFE ENVOY Hot Tub and how to prevent it?
Eye irritation in your HotSpring Hot Tub is often caused by low pH or low sanitizer levels. To fix this: * Adjust the pH. * Shock the spa with sanitizer and maintain the sanitizer level.
How do I fix algae growth in my HotSpring HIGHLIFE ENVOY?
Algae growth in your HotSpring Hot Tub is often due to high pH or low sanitizer levels. You can: * Shock the spa with sanitizer and adjust the pH. * Shock the spa with sanitizer and maintain sanitizer level.
What causes skin irritation or rash from my HotSpring HIGHLIFE ENVOY, and how to fix it?
Skin irritation or rash after using your HotSpring Hot Tub can be caused by unsanitary water or a free chlorine level above 5 ppm. To resolve this: * Shock the spa with sanitizer and maintain the sanitizer level. * Allow the free chlorine level to drop below 5 ppm before using the spa.
Why does my HotSpring HIGHLIFE ENVOY Hot Tub have a chlorine odor?
A chlorine odor in your HotSpring Hot Tub usually indicates a high chloramine level or low pH. Try these solutions: * Shock the spa with sanitizer. * Adjust the pH to the recommended range.
Why is my HotSpring HIGHLIFE ENVOY Hot Tub not heating, even though the jets and light are working?
If your HotSpring Hot Tub isn't heating but the jets and light are on, with the green "Ready" and blue "Power" logos blinking, it could be due to an open integrated pressure switch or a tripped circulation pump thermal cut-off. Here's what to check: * Check for clogged filters. The integrated pressure switch will reset when water flow through the heater is restored. Call for service if the heater trips frequently. * Check for clogged filters or air locks in the plumbing. Disconnect power to the spa and allow the circulation pump to cool. The circulation pump thermal cut-off will reset when the pump has cooled and power is reapplied. Call for service if the circulation pump thermal cut-off trips frequently.
How to troubleshoot a black touchscreen on my HotSpring HIGHLIFE ENVOY?
General| Seating Capacity | 5-6 |
|---|---|
| Jet Count | 43 |
| Pump | 2-speed |
| Filtration | Tri-X |
| Cabinet Material | Everwood HD™ |
| Control System | IQ 2020 |
| Lighting | LED |
| Warranty | 5-year shell warranty |
| Dimensions | 7'8" x 7'8" x 38" (234 cm x 234 cm x 97 cm) |
Crucial safety instructions that must be read and followed.
Safety guidelines to prevent child drowning and injury risks.
Precautions to prevent electrical shock hazards.
Dangers of prolonged immersion in hot water and symptoms of hyperthermia.
Step-by-step guide for initial spa setup and filling.
Guidelines for safe handling and use of spa chemicals.
Detailed steps for draining and refilling the spa.
Steps for removing and cleaning the spa filter cartridges.
Key considerations for choosing and preparing the spa's location.
Step-by-step guide for leveling the spa using shims.
Recommended ground preparation and foundation types for spa installation.
Troubleshooting power and heating issues related to RCDs/thermostats.
General troubleshooting guide for common spa problems.
To Next Page
