HOUNO Visual Cooking C - Entering and Changing Data in Steps

To Next Page

To Previous Page

PROGRAMS

STANDARD USER MANUAL 17

Entering and changing data in steps

By pressing when a program is active, the step display will show 1. The data of the ﬁrst

step can now be entered.

To move on to the next step press again.

Choose desired cooking function then set temperature, time, core temperature, exhaust,

humidity and fan speed as in manual operation.

Stop between steps: To sound an alarm between steps press a light will show for

conﬁrmation. The oven will not proceed to the next step until the oven door is opened and

closed or the alarm is pressed

To store a change made to a step mode, press until ‘Saved’ appears.

Note:

Be careful only to use the wheel when a value flashes. If you turn the wheel while you

are working in STEPS the computer switches to the next programme and all changes are

lost.

A step can be deleted by pressing step and alarm simultaneously for 2 seconds.

When a programme has started all parameters are adjustable. These changes will then only

be active in the current run. Note that the display shows the total time remaining after start

and that it will show the time remaining in the current step when you press