ROLL-IN SYSTEM
STANDARD USER MANUAL 19
ROLL-IN SYSTEM
The Roll-in system comes as standard on all 1.16, 1.20 & 2.20 models. The trolley can be
removed completely from the oven cabinet and replaced at will. This allows the oven to be
preheated whilst the trolley is being loaded.
Removing and replacing Roll-in trolley
Open the oven door by turning the handle 90° anti clockwise. the door must be open
minimum 100° to remove the trolley from the oven.
Insert the removable trolley handle bar into the holes near the base. Release the locks on
the wheels and carefully pull the trolley out of the oven cabinet.
Place the Preheat bridge into position at the bottom of the oven cabinet before closing the
oven door. The preheat bridge creates a seal in the space the trolley has left open so no
energy is lost during preheat.
The removable handle for the trolley can also be used to remove the
preheat bridge after heating. The preheat bridge can be hung on
the side if the oven.
The trolley can be replaced in the same way as removed.
Note: The preheat bridge is an optional extra.
Note: The Roll-in system oven must be installed on a level flat floor.
To protect the gasket of the oven door please ensure that the
wheels are locked once the oven trolley is in place.
To Next Page
Loading...