Hoval TopTronic E - Faults and Error Monitoring; Faults Menu Parameters

4 214 174 V00 KDT GLT-Modul TTE_EN.docx 22 / 26
15. Faults
In the Faults menu, it is possible to read out the active faults. In addition, the last 20 faults can be requested in the
error memory.
Fault output
If one or more controllers signal a fault, the correspondingly allocated output is switched on after the set triggering
delay has expired. If no controller signals a fault, the output is switched off.
If one or more controllers signal a fault, this is evaluated on the basis of the "error filter" data point. If the fault has one
of the categories according to the parameter, the output is switched on after the set triggering delay has expired. If the
fault has another category or if no fault occurs, the output is switched off.
If no output is allocated, the function has no effect.
15.1. Faults menu
Parameter
Designation
Value
Min.
Max.
Comment
R
W
29-042
Active error 1
xxx
0
0
Active error 1
0
7
29-043
Active error 2
xxx
0
0
Active error 2
0
7
29-044
Active error 3
xxx
0
0
Active error 3
0
7
29-045
Active error 4
xxx
0
0
Active error 4
0
7
29-046
Active error 5
xxx
0
0
Active error 5
0
7
29-040
Error memory
xxx
0
0
Error memory
4
7
32-045
Allocation SMA
collective fault
output
0
0
14
Allocation SMA collective fault output:
0=OFF, 4=DKP, 6=VA1, 7=VA2, 9=VA1-
FE1, 10=VA2-FE1, 11=VA3-FE1
4
4
29-041
Error to be
transferred
xxx
0
0
Error to be transferred
0
0
29-047
Module failure
xxx
0
0
Error resource monitoring
0
7
04-017
Collective fault
output delay
0.5 min
0.0
99.0
Collective fault output delay time
4
4
29-033
Error filter fault
output
3
1
4
Error filter fault output
3
3