To Next Page

To Previous Page

2-14

Installing the Switch

Installation Procedure

5. Connect the Network Cables

Connect the network cables, from the network devices or your patch panels,

to the fixed RJ-45 ports on the switch or to any SFP transceivers you have

installed in the switch.

When a network cable from an active network device is connected to the port,

the port LEDs for that port should go on. If the port LEDs do not go on when

the network cable is connected to the port, see “Diagnosing with the LEDs”

on page 4-2.

RJ-45 connector

100-ohm unshielded or shielded twisted-

pair cable:

• Category 3, 4, or 5 for 10 Mbps ports

• Category 5 only for 100 Mbps ports

• Category 5, 5e, or 6 for 1000 Mbps ports

Maximum distance: 100 meters

Other manuals for HP 1810-8G

Questions and Answers:

Need help?

Do you have a question about the HP 1810-8G and is the answer not in the manual?

General