Hood sensor
1. Prepare the computer for disassembly (Preparation for disassembly on page 21).
2. Remove the access panel (
Access panel on page 22).
3. From the inside of the chassis, if the hood sensor cable is secured to the fan cable with a plastic tie (1),
cut the tie to separate the cables.
4. Disconnect the hood sensor cable from the red system board connector labeled HOOD_SENSE(2).
5. Slide the hood sensor out of the slot in the rear of the chassis (3).
NOTE: Disengaging the hood sensor from the slot might require use of a flat tool.
To install the hood sensor, reverse the removal procedure.
46 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
