2 Enable the burst mode on both instruments.
Notice that the
Burst annunciator turns on.
3 Use the menu to set the burst count on both instruments.
After you enable the burst mode, the “recall menu” key will
automatically take you to the
BURST CNT command in the MOD MENU.
4: BURST CNT
4 Move down to the parameter level and set the count to “
INFINITE”.
Press the right or left arrow keys until the “
CYC” units are flashing.
Then, press the down arrow key to display “
INFINITE”.
INFINITE
5 Save the change and turn off the menu.
The function generator beeps and displays a message to show that the
change is now in effect. You are then exited from the menu.
ENTERED
Next, you will set up the starting phase of the burst as shown on
the next page.
Burst
Recall Menu
Shift
<
∨
Enter
Shift
1
Chapter 1 Quick Start
To phase lock using the triggered burst mode
11
To Next Page
Loading...
