HP 3314A - How to Use the N Cycle Mode 1; N Cycle Summary

HOW TO USE THE N CYCLE MODE
4
o
@ @
@
s..,
Key
PflESET
2
SST
3 SWfTA
INTVl
4 N
5
PHASE
Trigger from Channel 2 on the rIalng edge .
Presets the 3314A to 8 common starting point .
This key toggles the mode between N CYCLE and 1/2 CYCLE.
The Trigger Interval sets the time between the start of bonita. Note tha t if this time
Is shorter than the length of the burst. the output Is 8 continuous signe !.
Use the Modify knob to set the number of cycles In every burst .
ThIs parameter sets the start end stop phase of the burst.
N Cycle Summary
N range : 1 to 1999
SWrrA INTVl: .OO2ma to 1999.
Stert/Stop Phase: -90
0
to + 90
0
SYM range: 5% to 95%
See WaveformS' 31 through 36 In the Wavefonn Ubrary.
15