HP 3314A Operating Manual

88
The following examples clear or preset the indicated devices.
THE CLEAR MESSAGE
The 3314A responds to the device clear message (DCl), the selected device clear
message (SOC) and
the command "PR
n
by configuring itself to its initialized state.
Clears all devices on bus 7
Clears
3314A only
Presets 3314A only
CLEAR 7
CLEAR 707
OUTPUT 707;"PR"
Fftetill
"'-t e-litIN
fuet'"
Prwat e-fttIatl
Amplitude
100mVp-p (1OmVp-p et tum onl
Range Hold
Off
Amplitude Modulation
Off
SRO Mask (Status Byte)
not affected
ARB Mode
Off Stert Frequency
1kHz
ARB
Waveforms
not affected Status Byte (HP-IB)
cleared
Calibretlon
Exe<:utes a CAL ALL Stop Frequency
10kHz
Data Transfer Mode
not affect&d Storage R8i;llsters not affected
6 t (ARB)
not affected
Sweep
Off
Display ErrOfll (HP-IB) not affected
Sweep Mask (Status Byte)
not affected
Frequency
1kHz
Sweep Interval (Linear)
10ms
Frequency Modulation
Off
Sweep Interval (Log)
40ms
Function Invert
Off
Symmetry
50%
Menuel Sweep
Off
Trigger Intervel
1Oms
Merker Frequency
6kHz
Trigger Slope
I (positive)
Mode
Free Run
Trigger Source
lntarnal
N
1
Trigger Threshold
1V rrru
Offset
OVDC VCO
Off
Phsse
o Degrees Vector Height (ARB)
not effected
PU Mllsk [Status Bytel
not effect&d
The following table indicates the 3314A functions affected by the CLEAR message.
Notice
that "Status Byte (HP-IB)" is cleared by this message, but it is unaffected by
a preset.

HP 3314A Specifications

General

Brand	HP
Model	3314A
Category	Portable Generator
Language	English