HP 334A User Manual

Section M
Model 333A/334A
GENERAL SCHEMATIC NOTES
1. PARI'IAL REFERENCE DESIGNATIONS ARE SHOWN. PREFIX WITH
ASSEMBLY OR SUBASSEMBLY DESIGNATION(@ OR ECYI'H FOR
COMPLETE DESIGNATION.
2.
COMPONENT VALUES ARE SHOWN AS FOLLOWS UNLESS OTHER-
WISE NOTED
RESLSTANCE IN OHMS
CAPACITANCE IN MICROFARADS
3. DENOTESFRAMEGROUND.
4. $ DENOTESEARTH GROUND.
5. 6 DENOTES CHASSIS GROUND. (FLOATABLE)
0. DENOTES CIRCUTC GROUND. (ON BOARD)
7. --- - - -DENOTESASSEMBLY.
8. DENOTES MAIN SIGNAL PATH.
9. DENOTES FEEDBACK PATH.
10.
DENOTES REAR PANEL MARKING.
11* L-----J
12. DENOTES SCREWDRIVER ADJUST.
1-1 DENOTES FRONT PANEL MARKING.
r-----
13. ~~ENOTES FRONT PANEL CONTROL.
14.
* AVERAGE VALUE SHOWN, OPTIMUM VALUE SELECTED AT
FACI'ORY.
15. DENOTES COMPONENTS NOT MOUNTED ON
ASSEMBLY.
16.
DENOTES TROUBLESIIOOTmG INFORMATION LOCATED ON
APRON PAGE OF RESPECTIVE SCHEMATIC.
17.
t DENOTES DC VOLTAGE THAT MUST BE MEASURED WITH
io MCI/IO PF IMPEDANCE PROBE TO PREVENT OSCILLATIONS.
18. 0 DENOTES SIGNAL CONNECTION.
7-2

HP 334A Specifications

General

Brand	HP
Model	334A
Category	Measuring Instruments
Language	English