Touchpad click board
Table 5-11 Touchpad click board and cables descriptions and part numbers
Description Spare part number
Touchpad click board L24486-001
Touchpad board cable L23184-001
Touchpad click board cable L24485-001
Before removing the touchpad click board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 27).
2. Remove the rubber feet (see Computer feet on page 27).
3. Remove the bottom cover (see Bottom cover on page 29).
4. Remove the battery (see Battery on page 31).
To remove the touchpad click board:
1. Disconnect the touchpad cable (1) from the touchpad board ZIF connector, and then disconnect from the
touchpad click board cable (2) from the touchpad ZIF connector.
2. Remove the two Phillips M2.0 × 2.0 screws (3) that secure the touchpad click board to the computer.
3. Lift the tape that secures the board to the computer (4), and then remove the board from the computer
(5).
TIP: The edge of the board sits under clips. Be sure to slide the board out from under the clips to
prevent damage to the board or clips.
Reverse this procedure to install the touchpad click board.
Component replacement procedures 41
To Next Page
Loading...
