Display assembly
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 27).
2. Remove the rubber feet (see Computer feet on page 27).
3. Remove the bottom cover (see Bottom cover on page 29).
4. Remove the battery (see Battery on page 31).
To remove the display assembly:
1. Disconnect the display cable from the system board (1).
2. Remove the wireless antenna cables from their routing path under the USB board cable (2) and between
the fan and USB board and to the display (3).
3. Position the computer so it is open with the display hanging o the table (1).
4. Remove the four Phillips M2.5 × 6.0 screws (2) from the display hinges.
5. Remove the Phillips M2.5 × 3.0 screw (3) from the display hinges.
Component replacement procedures 51
To Next Page
Loading...
